Skip to main content

Backup Configuration

Backing up the configuration

To backup the configuration usingUsing the GUI

  1. Click on the user name in the upper right-hand corner of the screen and select Configuration > Backup.
  2. Direct the backup to your Local PCor to a USB Disk.

    The USB Disk option will not be available if no USB drive is inserted in the USB port. You can also backup to the FortiManager using the CLI.

  3. If VDOMs are enabled, indicate whether the scope of the backup is the entire FortiGate configuration (Global) or only a specific VDOM configuration (VDOM).

    If backing up a VDOM configuration, select the VDOM name from the list.

  4. Enable Encryption. Encryption must be enabled on the backup file to back up VPN certificates.
  5. Enter a password, and enter it again to confirm it. This password will be required to restore the configuration.
  6. Click OK.
  7. When prompted, select a location on the PC or USB disk to save the configuration file. The configuration file will have a .conf extension.

To backup the configuration usingUsing the CLI

Use one of the following commands:

execute backup config management-station <comment>

or:

execute backup config usb <backup_filename> [<backup_password>]

FTP

execute backup config ftp <backup_filename> <ftp_server> [<port>] [<user_name>] [<password>]

TFTP

execute backup config tftp <backup_filename> <tftp_servers> <password>

VDOM

Use the same commands to backup a VDOM configuration by first entering the commands:

config vdom

edit <vdom_name>

Restoring a configuration

To restore the FortiGate configuration usingUsing the GUI

  1. Click on the user name in the upper right-hand corner of the screen and select Configuration > Restore.
  2. Identify the source of the configuration file to be restored: your Local PCor a USB Disk.

    The USB Disk option will not be available if no USB drive is inserted in the USB port. You can restore from the FortiManager using the CLI.

  3. Click Upload, locate the configuration file, and click Open.
  4. Enter the password if required.
  5. Click OK.

To restore the FortiGate configuration usingUsing the CLI

execute restore config management-station normal 0

or:

execute restore config usb <filename> [<password>]

FTP

execute restore config ftp <backup_filename> <ftp_server> [<port>] [<user_name>] [<password>]

TFTP

execute restore config tftp <backup_filename> <tftp_server> <password>

The FortiGate will load the configuration file and restart. Once the restart has completed, verify that the configuration has been restored.

Back to top